Record - EverFocus EMV1200 FHD User Manual

6.2 Record

You can configure the basic record settings on this page.
Record Overwrite: Check the box to overwrite the hard disk / SD card when it is full. Note that
unless this box is checked, or the mobile DVR will stop recording when the hard disk / SD card is
full. The use of record overwrite is strongly recommended. If you do not use this feature, please
be sure to enable the Event setting for Storage Full for notification (see 6.3.5 Other). For SD card,
when the card is full, the "SD Card Disk Full" message will automatically pop-up.
Time Stamp: Select Top / Bottom to overlay time information on the top / bottom of the
recording streams. Select Off to disable the function.
Record Status Relay Output: Select a number to monitor the recording status of the selected
alarm relay. The recording status of the selected alarm relay will be transmitted to the alarm
output device.
Power Delay-On: Set the delay time to supply power to the mobile DVR in order to avoid

excess consumption surge at ignition.
Power Delay-Off: Set the delay time to power off the mobile DVR after ignition off. It can

extend the recording time after ignition off.
Save: Click to save the settings.
EMV1200 FHD / EMV800 FHD Hybrid Mobile DVR
73