Unit Installation - Garmin G5 User Manual

Installation Manual
1.3.3.2 ADDITIONAL EQUIPMENT REQUIRED
A 3/32" hex drive tool is required to secure the G5 to the panel as described in
Section 1.3.6.3 and shown in Figure 1-7.
Air hoses and fittings are required to connect pitot air and static air to the G5. The
G5 uses a female 1/8-27 ANPT fitting for each of these ports. Use appropriate aircraft
fittings to connect to pitot and static system lines.

1.3.4 UNIT INSTALLATION

Fabrication of a wiring harness is required. Sound mechanical and electrical methods
and practices are recommended for installation of the G5. Refer to Section 1.2.2 for
wiring considerations, and to Section 1.5 for pinouts.
Connector kits include backshell assemblies. Garmin's backshell connectors give
the installer the ability to quickly and easily terminate shield grounds at the backshell
housing. Instructions needed to install the Jackscrew Backshell and Shield Block
Ground can be found in the G3X Installation Manual (190-01115-01).
14
Garmin G5 User's Manual 190-02072-00 Rev. B