Garmin G5 User Manual page 78

Installation Manual
The GSA 28 pitch servo will control the elevator trim on the aircraft.
The Fastest Trim Motor Speed percentage is the speed at which the
pitch servo will run the auxiliary trim motor when at or below the
Trim Motor
corresponding airspeed.
Speed
The Slowest Trim Motor Speed percentage is the speed at which the
pitch servo will run the auxiliary trim motor when at or above the
corresponding airspeed.
The GSA 28 pitch servo has the ability to drive the auxiliary trim
motor at various speeds.
Slowest Auto The Slowest Auto Trim Motor Speed should be set so the auxiliary
Trim Motor trim motor will move as slowly as possible. The slowest possible
Speed (expert movement will ensure that there is no noticeable aircraft response
configuration) when the auxiliary trim motor is run during autotrim.
The Slowest Auto Trim Motor Speed can be adjusted from 5% to
100% in 5% steps.
The GSA 28 servos can limit the maximum continuous run time of
the trim motor. This can be used to help prevent the potential for a
trim runaway situation.
Maximum Trim
The Maximum Trim Run Time Limit is the maximum amount of time
Run Time
the trim servo will be run continuously when a manual electric trim
input is detected. If the maximum time is exceeded, the pilot will
need to release the Manual Electric Trim (MET) control and then
reassert it to continue running trim.
The GSA 28 pitch servo is capable of making very small adjustments
to fine tune the elevator position. The Fine Adjust Amount is the
amount in which these adjustments are made. Use the Fine Adjust
Fine Adjust
Amount and Fine Adjust Time to correct very small oscillations in
Amount (expert
the aircraft.
configuration)
Fine Adjust Amount is an expert configuration setting, and should
generally be not be changed by the installer. The default value is 0.
66
Garmin G5 User's Manual 190-02072-00 Rev. B