Garmin G5 User Manual page 141

FLIGHT DIRECTOR MODES
Flight director modes are normally selected independently for the pitch and roll axes.
Unless otherwise specified, all mode keys are alternate action (i.e., press on, press off).
In the absence of specific mode selection, the flight director reverts to the default pitch
and/or roll modes.
Armed modes are annunciated in white and active in green in the AFCS Status Box.
Under normal operation, when the control for the active flight director mode is pressed,
the flight director reverts to the default mode(s) for the axis(es). Automatic transition
from armed to active mode is indicated by the white armed mode annunciation moving
to the green active mode field and flashing for 10 seconds.
If the information required to compute a flight director mode becomes invalid or
unavailable, the flight director automatically reverts to the default mode for that axis.
A flashing yellow mode annunciation and annunciator light indicate loss of sensor or
navigation data required to compute commands. When such a loss occurs, the system
automatically begins to roll the wings level (enters Roll Hold Mode) or maintain the
pitch angle (enters Pitch Hold Mode), depending on the affected axis. The flashing
annunciation stops when the affected mode key is pressed or another mode for the
axis is selected. If after 10 seconds no action is taken, the flashing annunciation stops.
The flight director is automatically disabled if the attitude information required to
compute the default flight director modes becomes invalid or unavailable.
COMMAND BARS
Upon activation of the flight director, Command Bars are displayed in magenta on
the PFD Page. If the aircraft is being flown by hand, the command bars are displayed
hollow. The Command Bars do not override the Aircraft Symbol. The Command Bars
move together vertically to indicate pitch commands and bank left or right to indicate
roll commands.
190-02072-00 Rev. B Garmin G5 User's Manual
Pilot's Guide
129