Display The Wifi Radio Settings - NETGEAR WAX615 User Manual

Insight Managed WiFi 6 AX3000 Access Point Model WAX615
- Serial Number: The serial number of the access point.
-
Current Time: The current system time of the access point.
- Uptime: The time since the access point was last restarted.
• AP Interface Status: A green icon indicates that the interface is in use. A gray
icon indicates that the interface is not in use.
• IPv4 Settings section: The following settings are displayed:
- IPv4 Address: The IPv4 address of the access point.
- Subnet Mask: The subnet mask of the access point.
- Default Gateway: The default gateway for the access point.
- DHCP Client: The status of DHCP client (Enabled or Disabled).
• Wireless Settings section: The following settings are displayed, with separate
columns for the 2.4 GHz and 5 GHz radios:
- Antenna: The type of antenna (by default, 2x2).
- Wireless Mode: The operating WiFi mode of the radio.
- Channel / Frequency: The channel and frequency that are used by the radio.

Display the WiFi radio settings

To display the WiFi radio settings of the access point:
1. Launch a web browser from a computer that is connected to the same network as
the access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window displays.
If your browser displays a security warning, you can proceed, or add an exception
for the security warning. For more information, see What to do if you get a browser
security warning on page 39.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Monitor the Access Point and the
Network
166 User Manual