Mixing Scan Settings For A Multiple - Ricoh 1232 Series Operating Instructions Manual

Faxing
B Press [i
change the density.
2
Note
❒ You can select one of seven
density levels.
Combined Auto and Manual
Image Density
A Make sure that [Auto Image Den-
sity] is selected.
Note
❒ If [Auto Image Density] is not
selected, press [Auto Image
Density].
B Press [i
change the density.
Note
❒ You can select one of seven
density levels.
28
i Lighter] or [Darkerj i i
i Lighter] or [Darkerj
i i
j j ] to j
Mixing Scan Settings for a
Multiple Page Original
When sending an original consisting
of several pages, you can select differ-
ent image density, resolution and
original type settings for each page.
Place your original, select the scan
settings for the first page, dial and
press the { { { { Start} } } } key as you would
normally. Then follow one of the fol-
lowing two procedures.
Note
❒ While the machine is beeping, you
have about 60 seconds (10 for Im-
mediate Transmission) to select
density, resolution and original
type. The remaining time is shown
on the display.
A A A A
Check which pages you wish to
scan with different settings.
B B B B
Remove the previous page and
place the next page.
j ] to
j j
C C C C
Select the image density, resolu-
tion and original type.
Note
❒ Adjust settings for each page
before you press the { { { { Start} } } } key.