Measure Mode (Hp Auto Series) - Graco LineLazer V 200HS Operation

Measure Mode (HP Auto Series)

Measure Mode replaces a tape measure to measure
distances when laying out an area to be striped.
1. Use to select Measure Mode.
1
5
Ref. Description
1 Press to start measurement, Press to stop
measurement.
2 Hold to reset values to zero.
3 Job Data Logger, page 48.
4 Scroll between main menu screens
5 Last measurement taken
3A3426EOperation
2. Press and release auto gun trigger control. Move
3. Press and release auto gun trigger control to end
2 3
The most recent measured length is also saved as the
measured distance in the Stall Calculator display. See
Stall Calculator, page 41.
If an auto gun is activated, press and hold gun trigger
control at any time to apply a dot. If trigger is held while
striper is moving, a dot is marked every 12-inches
4
(30.5cm).
ti27914a
striper forwards or backwards. (Moving backwards
is a negative distance.)
measured length. Up to six lengths are viewable.
LineLazer V LiveLook Display
ti27842a
ti27842a
ti27915a
39