Cleanup - Graco LineLazer V 200HS Operation

Cleanup

Cleanup
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury from
pressurized fluid, such as skin injection, splashing fluid
and moving parts, follow the Pressure Relief
Procedure when you stop spraying and before
cleaning, checking, or servicing the equipment.
1. Perform Pressure Relief Procedure, page 11.
2. Remove guard and SwitchTip from all guns.
TI3371A
3. Unscrew cap, remove filter. Assemble without filter.
Both for 200
DC.
ti6269a
24
4. Clean filter, guard and SwitchTip in flushing fluid.
TI3375A
FLUSH
5. Place siphon tube set in grounded metal pail
partially filled with flushing fluid. Attach ground wire
to true earth ground. Perform Startup steps 10 - 17
(see page 13) to flush out paint in sprayer. Use
water to flush water-base paint and mineral spirits
solvent (also called white spirit) to flush oil-base
paint. Perform this step for both pumps for 200
sprayers.
6. Hold gun against paint bucket and pull trigger until
water or solvent appears. Repeat for additional
guns.
ti3322b
7. Move gun to solvent or water bucket. Hold gun
against bucket and pull trigger until the system is
thoroughly flushed. Repeat for additional guns.
8. Fill pump with Pump Armor, perform Pressure
Relief Procedure, page 11, then reassemble filter,
guard, and SwitchTip.
9. Each time you spray and store, fill throat packing
nut with TSL to decrease packing wear.
DC
3A3426EOperation