Table of Contents
Advertisement
LineLazer V LiveLook Display
Measure Mode (HP Auto Series)
Measure Mode replaces a tape measure to measure
distances when laying out an area to be striped.
1. Use
to select Measure Mode.
1
5
Ref. Description
1 Press to start measurement, Press to stop
measurement.
2 Hold to reset values to zero.
3 Job Data Logger, page 47.
4 Scroll between main menu screens
5 Last measurement taken
38
2. Press and release gun trigger control. Move striper
3. Press and release gun trigger control to end mea-
2
3
The most recent measured length is also saved as the
measured distance in the Stall Calculator display. See
Stall Calculator, page 38.
If an auto gun is activated, press and hold gun trigger
4
control at any time to apply a dot. If trigger is held while
striper is moving, a dot is marked every 12-inches
(30.5cm).
ti27914a
forwards or backwards. (Moving backwards is a
negative distance.)
sured length. Up to six lengths are viewable.
ti27842a
ti27842a
ti27915a
3A3426A Operation
Advertisement
Table of Contents
