Pairing The Remote Handset + Control Box Id Code - Regency Greenfire GF1500L Series Owners & Installation Manual

the heater.
PAIRING YOUR REMOTE CONTROL
The control box will only learn the remote ID codes during the first 30 seconds after power is applied.
After the first 30 seconds, the control box will ignore this special command.
letters "LC" will appear on the display indicating the ID codes have
The remote control handset has a set of unique ID codes that are pre-programmed into its memory. This set of
been transmitted.
ID codes helps differentiate one remote control handset from another; only the control box with a matching ID
code will respond to the appropriate remote control handset.
To match the control box, follow these steps:
1. Ensure the remote is siwtched off.
2. Remove the main power to the control box.
heater should light – spark, burner, etc even though the remote
3. Reconnect the main power to the control box.
screen says the heater is off.
4. Press and hold the PROG and FAN buttons simultaneously. The temperature display will show the letters
"LC", indicating the ID codes were transmitted, then revert to the normal off mode display.
5. Release the PROG and FAN buttons.
The control box will only learn the remote ID codes during the first 30 seconds after power is applied and will
ignore this special command from the remote afterward.
Note: The pairing process can be carried out by anyone.
work – fan speed can be adjusted, flame height can be adjusted, etc.
Note: Please visit www.regency-fire.com.au to see the pairing video.
Fan Operation
The fan must be on at all times while the unit is in operation. This model offers a two-speed fan.
table of contents
Greenfield® G1500L Gas Fireplace
| 3