Pairing Your Remote Control - Regency Greenfire GF1500LLP-2 Owners & Installation Manual

The control box will only learn the Remote ID codes during the first 30 seconds after power is applied
and will ignore this special command from the Remote after the first 30 seconds.
owner's information
To match the control box to the remote, follow the steps below :
To the New Owner:
1. Remove a battery from the remote handset.
Congratulations!
You are the owner of a state-of-the-art Gas Fireplace by REGENCY
2. Remove main power to the control box by turning off the isolation switch or switch on the GPO to
the warmth and charm of a wood fireplace at the flick of a switch. The model GF1500L has been approved by AGA for both
the heater.
safety and efficiency. As it also bears our own mark, it promises to provide you with economy, comfort and security for many
trouble free years to follow. Please take a moment now to acquaint yourself with these instructions and the many features of
3. Wait 30 seconds (approx.).
your Regency Fireplace.
®
4. Reconnect main power to the control box.

Pairing Your Remote Control

5. Immediately put the battery back in the remote & point the remote in the direction of the heater.
6. Press and hold the PROG and FAN buttons simultaneously. The
The control box will only learn the remote ID codes during the first 30 seconds after
power is applied. After the first 30 seconds, the control box will ignore this special
letters "LC" will appear on the display indicating the ID codes have
command.
been transmitted.
The remote control handset has a set of unique ID codes that are pre-programmed into its
memory. This set of ID codes helps differentiate one remote control handset from another; only
7. Release both buttons.
the control box with a matching ID code will respond to the appropriate remote control handset.
8. The display will revert back to the normal off mode display. The
To match the control box, follow these steps:
heater should light – spark, burner, etc even though the remote
1. Ensure the remote is siwtched off.
screen says the heater is off.
2. Remove the main power to the control box.
3. Reconnect the main power to the control box.
9. Press the Off button on the remote. The heater should turn off.
4. Press and hold the PROG and FAN buttons simultaneously. The temperature display will
show the letters "LC", indicating the ID codes were transmitted, then revert to the normal off
mode display.
10. Wait approx. 30 seconds turn the on again & check all the functions
5. Release the PROG and FAN buttons.
work – fan speed can be adjusted, flame height can be adjusted, etc.
The control box will only learn the remote ID codes during the first 30 seconds after power is
applied and will ignore this special command from the remote afterward.
Note: To view a step-by-step pairing video please visit
Note: The pairing process can be carried out by anyone.
regency-fire.com.au/Customer-Care/Fireplace-Care-Videos
Note: Please visit www.regency-fire.com.au to see the pairing video.
Fan Operation
Note: The Remote Control Handset has a set of unique ID codes that is
The fan must be on at all times while the unit is in operation. This model offers a two-speed fan.
pre-programmed into its memory. This set of ID codes helps to differen-
Note: The heater turns off when the room temperature reaches 1
tiate one Remote Control Handset from another so that only the control
and turns back on when the room temperature reaches 0.5
in AUTO mode.
box with a matching ID code will respond to the appropriate Remote
Control Handset.
regency.com.au
. The GF1500L has been designed to provide you with all
®
C over the set temperature
o
C under the set temperature when
o