Faceplate & Deflector Installation - Regency Greenfire GF1500L Series Owners & Installation Manual

FACEPLATE AND DEFLECTOR INSTALLATION FACEPLATE AND DEFLECTOR INSTALLATION
1. Install the fascia to the unit by hooking the left and right side
mounting brackets into the mounting slots at the side of the
firebox as shown below.
3 Mounting Slots
NOTE: When installing the stainless steel fascia, gloves
should be worn to prevent finger prints.
Diagram 2
NOTE: There are 3 mounting slots available, this is to accom-
modate any finishing that protrudes slightly beyond the faceplate.
It is recommended that you use the first mounting slot (the one
closest to the door frame overlay) out of the 3 so that the faceplate
and door frame overlay are flush with one another. See Diagram 2.
2. Install deflector by using 5 screws provided to the under-
side of the fascia as shown in Diagram 3 and 4.
Diagram 3
919-593b
Diagram 1
Verona Faceplate Shown
Diagram 4
Deflector
Installed
Diagram 5
3. Hook the inner door frame to the unit. Refer to "Screen and
Inner Door Frame Installation" in the manual prior to install-
ing it on to the unit.
4. Remove any finger prints/ marks prior to operating the unit.
5. GF1500LST only: Repeat Steps 1-4 to install Faceplate and
Deflector on opposite side.
WARNING: Turn off the unit by way of the wall switch or
remote. Allow unit to cool at least 10 min. - prior to remov-
ing the faceplate.
1
GF1500
installation
5 screws
Diagram 4
Diagram 6
Greenfield® G1500L Gas Fireplace
| 43
07.18.16