Table of Contents
Advertisement
4.
Loosen (4) motor mounting hex nuts (see
Figure 112) to release belt tension.
V-Belt
Figure 112. Location of V-belt and motor
mounting hex nuts.
5.
Slip old V-belt off pulleys, then install new belt
in its place.
6.
Have
assistant
until deflection is approximately
Figure 113), then tighten hex nuts from
Step 4.
Deflection
Figure 113. V-belt deflection.
7.
Perform Steps 2–5 of Installing Blade on
Page 36 to install blade.
8.
Install V-belt cover.
Model G0960 (Mfd. Since 09/22)
x 4
adjust
motor
position
⁄
" (see
1
4
Bandsaw
Wheel
⁄
"
1
4
Motor
Wheel
Calibrating Blade
Height Scale
Use the following steps to adjust the scale indica-
tor so it is equal to the distance between the blade
and the log bunks.
Item Needed
Measuring Tape ................................................. 1
To calibrate blade height scale:
1.
DISCONNECT MACHINE FROM POWER!
2.
Confirm that blade tension (Page 36) and
blade guides (Page 39) have been adjusted
correctly.
3.
Confirm saw head is level by performing
Steps 63–65 of Assembly on Page 30.
4.
Measure distance between back of blade to
top of log bunk.
— If distance between back of blade and log
bunk is equal to value shown on scale, no
adjustment is necessary.
— If distance between back of blade and log
bunk is not equal to value shown on scale,
proceed to Step 5.
5.
Loosen knob shown in Figure 114, adjust
indicator to value measured in Step 4, then
tighten knob to secure.
Scale Indicator
Knob
Figure 114. Location of scale indicator knob.
Qty
Scale Indicator
-57-
Advertisement
Table of Contents
