Table of Contents
Advertisement
Unpacking
This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage. If items are damaged,
please call us immediately at (570) 546-9663.
IMPORTANT: Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.
Needed for Setup
The following are needed to complete the setup
process, but are not included with your machine.
Description
•
Safety Glasses ........................................... 1
•
Cleaner/Degreaser ..................... As Needed
•
Disposable Shop Rags ............... As Needed
•
Disposable Gloves ..................... As Needed
•
Phillips Screwdriver #2 (G0959) ................. 1
•
Dust Hose (G0958–2
•
Hose Clamp (G0958–2
•
Dust Collection System .............................. 1
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Model G0958/G0959 (Mfd. Since 05/22)
SECTION 3: SETUP
Qty
⁄
", G0959–4") ......... 1
1
2
⁄
", G0959–4") ...... 1
1
2
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
B
E
H
I
J
Figure 8. Model G0958/G0959 inventory.
Box 1 (Figure 8)
A. Jointer/Planer Unit (Not Shown) ................. 1
B. Fence Assembly ......................................... 1
C. Planer Table Height Crank ......................... 1
D. Dust Port Assembly .................................... 1
E. Push Block ................................................. 1
F.
Hex Wrench 4mm ....................................... 1
G. T-Handle Torx Wrenches T-20 ................... 2
H. Push Stick .................................................. 1
I.
Indexable Carbide Inserts 15 x 15 x 2.5mm.. 5
J.
Flat Head Torx Screws T-20 M5-.8 x 12 ..... 5
K. Cap Screws M5-.8 x 20 (G0958 Fence) ..... 2
L. Flat Washers 6mm (G0959 Fence) ............ 2
M. Button Head Cap Screws M6-1 x 16
(G0959 Fence) ........................................... 2
C
D
G
F
K
L
M
Qty
-19-
Advertisement
Table of Contents
