Connector Check And Replacement Check - Toshiba Satellite 1400 Series Maintenance Manual

2 Troubleshooting Procedures
Procedure 5

Connector Check and Replacement Check

The HDD or the system board may be disconnected or damaged. Disassemble the computer
following the steps described in Chapter 4, Replacement Procedures and perform the following
checks:
Check 1 Make sure the HDD is firmly connected to PJ7000 on the system board.
If the connection is loose, reconnect firmly and repeat Procedure 1. If there is still an
error, go to Check 2.
Check 2 The HDD may be damaged. Replace it with a new one following the instructions in
Chapter 4. If the problem still exists, perform Check 3.
Check 3 The system board may be damaged. Replace it with a new one following the
instructions in Chapter 4.
2-42
HDD
Satellite 1400/2400 Series Maintenance Manual (960-364/365)
2.6 HDD Troubleshooting
PJ7000 System board