4.13 HDD Connector Board
4.13 HDD Connector Board
Removing the HDD Connector Board
To remove the HDD connector board, follow the steps below and refer to figure 4-32.
1. Remove two M2×5 thin silver flat-head screws securing the HDD connector
board.
2. Carefully lift up the HDD connector board to disconnect it from PJ2000 on the
system board.
3. Lift out the HDD connector board.
PJ7001
PJ2000
Figure 4-32 Removing the HDD connector board
Satellite1400/2400 Maintenance Manual (960-364/365)
4 Replacement Procedures
M2×5 thin silver flat-head screws
HDD connector board
4-49