4 Replacement Procedures
4. Turn over the power switch board.
5. Disconnect the SUMI card from PJ7200.
Installing the Power Switch Board
To install the power switch board, make sure that the computer is in boot mode and powered
off, follow the steps below and refer to figures 4-18 and 4-19.
1. Connect the SUMI card to PJ7200 on the power switch board.
2. Seat the power switch board.
3. Secure the power switch board with one M2.5×4 black flat-head screw.
4. Connect the SUMI card to PJ2018 on the system board.
4-34
PJ7200
Figure 4-19 Disconnecting the SUMI card
Satellite 1400/2400 Maintenance Manual (960-364/365)
4.7 Power Switch Board
SUMI card