4.33 TFT FL (Model 14.1 Toshiba)
Installing the TFT FL (Model 14.1" Toshiba)
To install the TFT FL (Model 14.1" Toshiba), follow the steps below and refer to figures
4-118 to 4-123.
1. Remove non-adhesive backing from the left and right sides of the FL unit.
2. Make sure the FL lights.
3. Make sure there is no dust or other foreign matter or damage to the FL unit.
4. Make sure the cell is not damaged, then seat the PCB-ASSY cell on the FL unit.
The prism sheets or others
must not lie on the frame.
Satellite 1400/2400 Series Maintenance Manual (960-364/365)
Secure the tab on the prism sheets firmly
with the sheet-holding tape.
Secure the tab on the prism sheets firmly
with the sheet-holding tape.
Secure the tab on the prism sheets firmly
with the sheet-holding tape.
Figure 4-118 Installing the PCB-ASSY cell
4 Replacement Procedures
The prism sheets or others
must not lie on the frame.
tape
4-145