Installing The Tft Fl (Model 14.1 Sharp) - Toshiba Satellite 1400 Series Maintenance Manual

4.30 TFT FL (Model 14.1 Sharp)

Installing the TFT FL (Model 14.1 SHARP)

To install the TFT FL (Model 14.1 SHARP), follow the steps below and refer to figures 4-90
to 4-94.
1. Install a new FL.
2. Seat the lamp cover on the LCD module aligning the holes on the lamp cover with
the pins on the LCD module. Leave the P-chassis on the outside by the outlet of the
wire.
3. Fold the shield tape down.
4. Secure the lamp cover with two screws.
Tighten the screws with 0.1176N⋅m (1.2kgf⋅cm) of torque.
Satellite 1400/2400 Series Maintenance Manual (960-364/365)
Screw
Figure 4-90 Installing the lamp cover
4 Replacement Procedures
Pin
Lamp cover
Screw
Pin
4-117