Switcher-Initiated Messages; Error Codes; Using The Command And Response Table - Extron electronics SW USB Pro Series User Manual

To log in to the SW USB Pro via Ethernet or Ethernet over USB:
•
•

Switcher-initiated Messages

When a local event such as a front panel selection takes place, the switcher responds by
sending a message to the host, indicating what selection was entered. No response is
required from the host.
The switcher sends the following copyright message when it first powers on.
© Copyright 20
where SW
firmware version number.

Error Codes

If the switcher is unable to execute a command it receives because the command is invalid
or contains invalid parameters, the SW USB Pro returns an error response to the host:
E01 — Invalid input channel number (out of range)
E06 — Invalid switch while in auto-switch mode
E10 — Invalid command
E13 — Invalid value (out of range)
E14 — Not valid for this configuration
E24 — Privilege violation
E26 — Maximum number of connectors exceeded
E28 — Bad filename or File not found

Using the Command and Response Table

The
ASCII command codes, the responses of the switcher to the host, and descriptions of the
command functions or the results of executing the commands. The ASCII to Hex Conversion
Table below is for use with the Command and Response Table.
Space
User name = admin
Password = {unit serial number} if the unit is new, extron if the unit has had an
absolute system reset.
NOTE: Performing a unit factory reset (entering a ZQQQ
SIS command or a Mode 5 reset
serial number password to extron.
, Extron Electronics, SW
nn
is the switcher model number as well as the number of inputs, and V
n
Command and Response Table for SIS Commands
ASCII to Hex Conversion Table
SW USB Pro Series • Remote Configuration and Control
[Absolute system
via the rear panel button) changes the
Reset
USB Pro, V . 60-183
n n nn,
on page 22 lists valid
•
reset]
01
n-
is the
n.nn
19