Table of Contents
Advertisement
Installation
Observe when installing further devices, that you can pull out the name plate glass downwards. Do not
mount another device below a device.
Installation site
To achieve an optimal video image quality do not point out the
camera to
solar radiation
strong sources of light
bright or strongly reflecting walls
Mounting height
Observe the detection angle of the camera when selecting the
mounting height of the video front door station (see PIC on the
right side). Persons with an average body height are detected
optimal at a mounting height of 1.6 m above the ground.
CAUTION!
The front door station must never be sealed using silicon! Condensed water must be able to escape and
evaporate.
Opening and closing the housing
The lower aperture is connected to the aluminium profile with
2 hexagon socket screws.
► Loose both screws with an allen key.
► Now you can face away or remove the lower aperture.
► Pull out the name plate glass downwards.
► Guide the cable through the cable gland.
► Mount the device to the wall using the attachment holes and
suitable screws.
Ensure that the wires are not getting clamped below the spac-
ers at the rear side of the front door station.
► Slide the name plate glass upwards below the front panel.
► Fix the lower aperture again.
Ensure that the rubber seals within the guidance slot are not damaged when sliding in the name plate
glass.
Device damage.
9
Advertisement
Table of Contents
