Bell Button Programming; Basic Principle; Legend - TCS AVD Series Product Information

Bell button programming

Basic principle

All devices at the TCS:BUS have an unique serial number.
The serial number of the indoor station is allocated to the bell button of the front-door station. The allocation is
stored in the EEPROM of the front-door station.
Requirements for the programming:
► Ensure that the access to the indoor station in the flat is granted.
► Check if the indoor station is connected to the TCS:BUS.
► Switch on the mains voltage. The operating LED at the power supply and control unit is on.
► Check if no programming lock is set.
Before you can reprogram an already programmed bell button, you have to delete the programming.

Legend

press button shortly
Press the button until...
release the button
go on
ring tone
Progsperr-tone
Audio files of the call and acknowledgement tones are available online at: www.tcsag.de/download/ruf-
und-quittungstoene
busy tone
a negative acknowledgement tone sounds
(bell button is already programmed)
SNapp-tone
NoProg-tone (negative acknowledgement
tone)
deletion tone sequence
Prog2-tone (programming of the 2nd serial
number starts)
15