Labelling The Name Plates; Configuration; Factory Settings - TCS AVD Series Product Information

The volumes are set on an average value ex works. A change is
not always required. Observe that the amplification cannot be
set independently from each other when adjusting the volume
of loudspeaker and microphone. In case of a high volume, the
feedback effect (audible whistling) occurs.

Labelling the name plates

The labelling templates for the series AVD/AVE are available
for download under
www.tcsag.de/download/beschriftungsvorlagen/
at our website.
Enter the required names into the labelling template.
Print the name plates on the special foil.
Cut the name plates to the right size.
Push the name plate into the gab in the name plate glass from
aside (ill. 11).
Print the name plates on the special foil. You can order the foil
directly at TCS: Writeable polyester film for name plates DIN
A4.

Configuration

The front door station is to be configured as two separate devices: Front door station PES and code lock.

Factory settings

The front door station is equipped with an EEPROM. In there the following settings are stored ex works:
AS-address for door release function
programming lock
The programming mode can only be set at the control unit
acoustic acknowledgement of the bell button confirmation
send light switch protocol when pressing the # button
access codes 2 to 10 (on memory location number 2 to 10)
master code
extended code lock function (with additional condition)
Volume control
microphone
Setting the volume at the
indoor station
0
OFF = 0
ON = 1
active = 1
active = 1
not assigned
12345678
OFF = 0
loudspeaker
Setting the volume at the
front door station
13