Delete The Programming; Programming The Code Lock; Notes On The Programming - TCS AVD Series Product Information

Delete the programming

Before an already programmed bell button can be programmed newly, the programming must be deleted.
1 Switching on the programming mode
power supply and control unit
Shortly press the RUN/PROG button.
2 Delete a bell button
Press the bell button until the deletion tone sequence sounds.
4 End programming mode
Shortly press the RUN/PROG button.

Programming the code lock

Notes on the programming

 confirm with the # button
 abort with the * button
 Entries without confirmation have a timeout of 10 sec, an acknowledgement tone signals the countdown of the
timeout
 factory settings of the 10 code memory locations are shown in brackets (e.g. WE = 0)
 SpNo = number of the memory location
18
The LED blinks.
The LED is on.
The programming mode of the system is switched ON.
Release the bell button.
The programming mode of the system is switched
OFF.