Switch Off The Programming Mode - TCS AVD Series Product Information

2e Determine options
2f Block manual programming
Determine the
extended code lock function
2g Change master code
2h Reload factory settings

Switch off the programming mode

2i Quit the programming mode
20
Input: * 5 # option # value #
option
0 send light switch protocol
3 acoustic acknowledgement
buttons
4 programming mode can only
be activated after the pro-
gramming mode of the control
unit was activated
The factory setting is valid for stand alone operation. To
improve the safety, activate the option 4 (putting the
value to 1) during the BUS operation. Thus, the access
to the control unit is an additional condition.
Input: * 10 # master code #
master code = number with a maximum of 8 digits
The programming lock cannot be deactivated manually,
but only with configo
Input: * 12 # function type #
Function type:
0 = external contact has no influence
1 = contact must be opened so that the code input can be effective
2 = contact must be opened so that the code input can be effective
Input: * 98 # old master code # new master code #
new master code = number with a maximum of 8 digits
Change the pre-set master code when commissioning
the device.
Input: * 99 # master code # master code #
master code = number with a maximum of 8 digits
All saved numeric codes are deleted. The master code
is reset to the factory setting.
Input: * 9 #
value
0 = no, 1 = yes (WE = 1)
0 = off, 1 = on (WE = 1)
0 = no, 1 = yes (WE = 0)
TM .
new master code #