Meters And Gauges - Shindaiwa DGK180F Owner's And Operator's Manual

■ DEF Indicator Lamp Action
LAMP
State
Stage-Ⅰ
Warning
Stage-Ⅱ
Early Inducement (Slow Blinking)
Stage-Ⅲ
Final Inducement
(Quick Blinking)
（Engine Shutdown）
ESCAPE MODE
(Quick Blinking)
(4) Operating Escape Mode
This mode allows you to restart the engine that forcibly shut down due to DEF shortage or SCR
system error.
A total of 30 minutes of time operation is possible for urgent needs.
1
Set the ACCESSORY switch to ON position.
2
Loosen the knob on the operation panel and
open the panel.
3
Press the Escape Mode switch (blue button) in
the control box. (Make sure that the escape
mode lamp is lit.)
4
Close the operation panel and tighten the knob.
5
Set the ACCESSORY switch to OFF, and use
the safety cap to cover it.
6
Set the STARTER SWITCH selector to START
position.
< Note >
 ESCAPE MODE is available for total up to 30
minutes. On and after 30 minutes, the procedure
above described is never applicable, and the engine
never restarts.
 Upon completing repair during ESCAPE MODE, it
automatically switches back to the normal mode.

5-6. Meters and Gauges

Engine Meters and Gauges
(1) Hour Meter
Displays the operating time. Use this as a reference for managing
periodic inspection interval. Be careful as the hour meter operates
when the ACCESSORY switch is at ON position regardless of engine
is running or not, and / or when the engine shuts off abnormally when
STARTER SWITCH is set at START position or AUTO position
(Except when Over Crank Indicator illuminate or flashing).
EXH.
DEF
SYSTEM
○ ○
(Turn ON) (Turn ON)
○ ○
(Turn ON)
○ ○
(Turn ON)
○ ○
(Turn ON)
NO POWER
ENGINE
（SHUTDOWN）
－
(Turn ON)
－
(Turn ON)
○
(Turn ON) (Turn ON)
－
(Turn ON)
Knob
Operation Panel
Escape Mode Switch
(Blue Button)
18
ESCAPE
MODE
○
－
○
－
○
－
○ ○
(Turn ON)
Control Box