Shindaiwa DGK180F Owner's And Operator's Manual page 24

< Note >
 Set the STARTER SWITCH selector to STOP to activate this function.
 Do not leave the ACCESSORY switch at ON position. This is causing battery from drain out.
(3) Breaker
This switch is for transmitting electrical power to the load side. Turn to ON position to output
voltage to the output terminals. Output to the load side is cut off when there is a short circuit or
overload on the load side.
< Note >
 Do not turns off/on the breaker manually to operate or stop a load.
(4) Breaker Trip Selector Switch
This switch is for selecting the tripping order of the three-phase and single-phase breaker when
there is a short circuit or overload on the load side. If the three-phase or single-phase breaker
is selected for precedence in tripping, the selected breaker will trip first when the total generator
output exceeds the rated capacity.
After that, the other breaker will also trip if the generator output exceeds the rated capacity
again.
 Switch Selection
 
 1
 "3 ": The three-phase breaker trips first followed by the single-phase breaker.
 "Simultaneous (3
 
 3
 "1 ": The single-phase breaker trips first followed by the three-phase breaker.
(5) Ammeter Selector Switch
This switch is for selecting the output current indicated by the ammeter. Change the switch to
display the following output terminal current on the ammeter.
 Switch Selection
 "L1+U": Three-phase L1 phase + Single-phase three-wire U phase (total)
 "L2": Three-phase L2 phase
 "L3+W": Three-phase L3 phase + Single-phase three-wire W phase (total)
< Note >
 If measuring the output current for a single-phase three-wire type, turn the ammeter selector
switch to "L1+U" or "L3+W". The voltage cannot be accurately measured if set to "L2".
Voltage Regulator/Throttle Switch
(1) Voltage Regulator
This dial is for regulating voltage output by the generator. Turn
the dial clockwise to increase the voltage and counterclockwise
to decrease it.
(2) Throttle Switch
This switch is for changing the engine speed. Set to IDLING
when starting, warming up and cool down the engine, and set to
RUN during rated operation.
< Note >
 The engine is running at 1800rpm with 60Hz regardless of throttle switch position if you leave
starter switch in AUTO position.
 
)": The three-phase and single-phase breakers trip simultaneously.
 1
Voltage Regulator
Throttle Switch
21