Shindaiwa DGK180F Owner's And Operator's Manual page 61

Problem
White smoke 1. Too much or too little oil to cylinder
comes out from 2. Water is interfused in fuel line
Muffler 3. Fuel injection nozzle is defective
4. Coolant temperature is too low
5. Engine thermostat is defective
Pointer (hand) does not 1. Voltage meter is defective
move in voltage meter 2. AVR is defective
3. Disconnected circuit, loose terminal or
4. Initial exciter is defective
5. Alternator is defective
6. AVR protective device operation
Pointer (hand) 1. Voltage meter is defective
does not goes up 2. AVR is defective
to the rated 3. Voltage regulator dial is defective
voltage
Pointer exceeds 1. Voltage meter is defective
the rated voltage 2. AVR is defective
3. Improper load cable connection
4.Voltage switch is set to 480 V
The voltage drops 1. AVR is defective
drastically when 2. Unbalanced loads sharing to each
connecting to load
3. The current of the used equipment
4. Over load
5. AVR protective device operation
Cannot turn the 1. The Main breaker positions at between
breaker to ON
2. Short circuit on the load
Suspected cause
departed
terminal
exceeds the rated current
ON and OFF
1. Contact distributor or dealer for repair
2. Drain water in fuel filter or fuel tank
3. Contact distributor or dealer for repair
4. Warm-up driving is needed
5. Contact distributor or dealer for repair
1. Contact distributor or dealer for repair
2. Contact distributor or dealer for repair
3. Contact distributor or dealer for repair
4. Contact distributor or dealer for repair
5. Contact distributor or dealer for repair
6. Replace AVR fuse
1. Contact distributor or dealer for repair
2. Contact distributor or dealer for repair
3. Contact distributor or dealer for repair
1. Contact distributor or dealer for repair
2. Contact distributor or dealer for repair
3. Correctly set the connection location to
the receptacle
4. Set the voltage switch to 240 V
1. Contact distributor or dealer for repair
2. Balance the loads sharing to each
terminal
3. Change to a device with an available
capacity
4. Decrease the loads to meet the rated
output
5. Replace AVR fuse
1. Once turning the lever to OFF, turn it to
ON
2. Check the load circuit
58
Action