Meters And Gauges - Shindaiwa DGK60D Owner's Manual

(3) OVER SPEED (Engine Overspeed) Warning Indicator
This generator is equipped with a function such that the engine is automatically stopped if an
engine fault occurs causing the engine speed to increase excessively. If the engine speed
rises above 2070 rpm during operation, the OVER SPEED and ENGINE warning indicators
light up, and the engine automatically stops. If this occurs, it is probable that some
malfunction has occurred in the engine. Contact the authorized distributor where the
generator was purchased.
(4) BATTERY (Battery Charge) Warning Indicator (Low Battery Voltage)
The BATTERY warning indicator lights up when charging is not possible during operation. If
charging is not possible and the battery voltage drops below 8 V, the ENGINE warning
indicator also lights up and the engine automatically stops. If this occurs, contact the
authorized distributor where the generator was purchased.
< NOTE >
 This battery charging warning indicator cannot detect battery deterioration or insufficient battery
fluid. (Refer to section "8-7. Checking the Battery".)
(5) AIR FILTER (Air Cleaner Clogging) Warning Indicator
The AIR FILTER warning indicator lights up if the air cleaner element becomes clogged
during operation. If it lights up, immediately stop the engine and clean or replace the air
cleaner element.
(Refer to section "10. Inspection/Maintenance (3) Air Filter Element Cleaning/
Replacement".)
(6) SPILL CONTAINMENT (Spill Containment Amount) Warning Indicator
The SPILL CONT warning indicator lights up if the liquid stored in the spill containment
exceeds approximately 10 gal. during operation. If it lights up, immediately stop the engine
and flush the liquid stored in the spill containment.
(Refer to section "10. Inspection/Maintenance (8) Flushing Liquid in Spill Containment".)
< Note >
 The engine may not be stopped only if the spill containment warning Indicator illuminates during
operation.
 When the spill containment warning Indicator illuminates during operation, stop the engine, check
for fuel, oil and cooling water leakage, and repair as necessary.
 Do not use the equipment with liquid accumulated in the spill containment. Drain the spill
containment before using.
(7) ENGINE (Engine Malfunction) Warning Indicator
The ENGINE warning indicator lights up if the coolant temperature is high, the oil pressure is
low, the engine overspeeds, the battery voltage is low or some other engine fault occurs
during operation. If this occurs, a malfunction code is displayed on the engine and available
output monitors, and the engine automatically stops or the engine output is reduced.
If the ENGINE warning indicator lights up, contact the authorized distributor where the
generator was purchased.

5-4. Meters and Gauges

Engine Meters and Gauges
(1) Hour Meter
Displays the operating time. Use this as a rough
estimate for managing the timing of periodic inspection.
11
Oil Press
Water Temp
Speed
Fuel Meter
Selector
Switch
Hour Meter
時間計