Complete The Installation Process (On S8300 Primary Controller Only) - Avaya G700 Installation And Upgrades

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Configure the Destination for G700 SNMP Traps
Begin
Events occurring on the G700 cause SNMP traps to be generated. The G700 MGP can be configured
to send SNMP traps to any network management system (NMS) in the network, including the
primary server (S8300/S8700). The MGP CLI set snmp trap command is the way to configure the
NMS network element that will receive those traps. The traps are sent in User Datagram Protocol
(UDP) on the customer's IP network.
The command syntax is:
set SNMP trap <IP address> {enable|disable}
[{all|power|temp|app|module|config|voice|operations}]
where <IP address> is the IP address of the NMS trap receiver that will be receiving the traps
from the G700, and
[{all|power|temp|app|module|config|voice|operations}] indicates the groups whose traps will be
sent to the specified receiver. If no keywords follow the IP address entry, then 'all' traps will be
enabled for the specified receiver.
If 'enable' or 'disable' is used without a trap designation keyword, then 'all' traps is assumed. Up
to ten trap receivers can be configured.
From the L2 Processor CLI, type session mgp
1.
At the mg-xxx-n(super-user) prompt, type configure and press Enter.
2.
At the mg-xxx-n(configure) prompt, type set snmp trap <IP address> enable and press Enter.
3.
Type exit
4.
End
Complete the Installation Process (On S8300
Primary Controller Only)
Consult the planning documentation to obtain the necessary information to complete the installation. Part of
the final process will be to:
• Connect and administer test endpoints
• Test the endpoints
• Administer MultiVantage for trunks, features, networking, or other items required by the customer.
• Complete the electrical installation
• Enable adjunct systems
142
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002