Avaya G700 Installation And Upgrades page 209

5 Upgrading an Existing G700 with an S8300 (Primary Controller or Local Survivable Processor):
Determine Necessary Firmware to Install on the G700
Begin
The first steps determine if new firmware for the P330 Stack Processor is necessary.
At the P330-1(configure)# prompt, type dir
1.
The list of software appears.
Figure 97. Directory List for P300 Processor
2. Check the version number of the EW_Archive file to see if it matches the Release Letter. If not,
you must upgrade the P330 Stack Processor.
3. At the P330-1(configure)# prompt, type show image version
The list of software appears.
Figure 98. Show Image Version List for P330 Processor
P330-1(configure)# show image version 3
Mod Module-Type
------ -----------
3 Avaya G700 Media Gateway
3 Avaya G700 Media Gateway
Check the version number of the stack software image file to see if it matches the Release Letter.
4.
If not, you must upgrade the P330 Stack Processor.
The next steps determine if new firmware is required for the G700 Media Gateway Processor (MGP),
the VoIP Module, and the installed Media Modules.
5. At the P330-1(configure)# prompt, type session mgp
At the MG-001-1(super)# prompt, type configure
6.
7. At the MG-001-1(configure)# prompt, type show mg list_config
The list of software appears.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
.
Bank
----
Version
-------
A 0.0.0
B 3.8.2
209