Insert The Media Modules - Avaya G700 Installation And Upgrades

2 Installing Hardware for the G700 Media Gateway and S8300 Media Server:
Figure 10. Tighten screws

Insert the Media Modules

Following the planning documentation, you can insert the required Media Modules into their designated
bays. The G700 Media Gateway can accommodate up to four Media Modules, or plug-in circuit packs. The
choice of Media Modules is dictated by the offer selected by the customer and the configuration of the
system.
Consult the planning documentation and the order form to determine which modules you will be installing.
The planning documents also indicate into which slots the modules are to be inserted. The Media Modules
available at this time are:
• Avaya™ MM710 T1/E1 Media Module
• Avaya™ MM760 VoIP Media Module
• Avaya™ MM711 Analog Media Module
• Avaya™ MM712 DCP Media Module
• Avaya™ MM720 BRI Media Module
For detailed descriptions of the Media Modules see "Avaya MultiVantage™ Solutions Hardware Guide,
555-233-200".
!
WARNING:
The Avaya G700 Media Gateway must not be operated with any slots open. Failure to
cover empty slots with the supplied blank plates can cause overheating due to
inadequate air distribution.
!
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or if
misaligned and then forced into position.
!
CAUTION:
Separate ESD paths to the chassis ground connect to the Media Modules at the spring-
loaded captive screws. Ensure the captive screws are securely tightened to prevent damage
to the equipment.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
Insert the Media Modules
51