Avaya G700 Installation And Upgrades page 52

2 Installing Hardware for the G700 Media Gateway and S8300 Media Server:
Insert Media Modules
Begin
Remove the blank plate from the empty bay.
1.
2. Position the Media Module squarely before the selected bay on the front of the G700 Media
Gateway chassis and engage both sides of the module in the interior guides.
3. Slide the module slowly into the chassis, maintaining an even pressure to assure that the module
does not become twisted or disengaged from the guides.
Figure 11. Insert Media Module
Apply firm pressure to engage the connectors.
4.
The Media Module connector has different length pins. The long pins will engage first to provide
grounding. Medium length and short pins will provide power and signal.
5. Lock the Media Module into the chassis by tightening the spring-loaded captive screws on the
front of the module.
End
!
WARNING:
To prevent access to electrical hazards by unauthorized personnel and to ensure
continued compliance to international radiated emissions requirements, all captive
screws must be securely tightened such that they cannot be loosened without the
use of a tool.
!
WARNING:
After you have connected telephones to the various Media Modules, be sure to add
circuit protection to the lines (See "Complete the Telephone Installation Process" on
page 241).
At this point, you have readied the G700 inserted the S8300 if required, and inserted the Media Modules,
as described in the planning documentation. Next, if required, the Expansion Module should be inserted into
its bay.
52
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
Insert the Media Modules