Omron CPM2C Operation Manual page 98

1, 2, 3...
1, 2, 3...
4-2 SYSMAC Support Software (SSS)
4-2-1 Introduction
Checking Operation in MONITOR Mode
Use the following procedure to switch the CPM2C to MONITOR mode.
1. Make sure that the SYSMAC-CPT Support Software is online. Select "On-
line (O)" from the menu bar, select "Mode (M)," and then "MONITOR (M)."
2. A confirmation message will be displayed. Click "OK" to switch to MONITOR
mode.
Starting Operation in RUN Mode
Use the following procedure to switch the CPM2C to RUN mode.
1. Make sure that the SYSMAC-CPT Support Software is online. Select "On-
line (O)" from the menu bar, select "Mode (M)," and then "RUN (R)."
2. A confirmation message will be displayed. Click "OK" to switch to RUN
mode.
The SSS is a complete programming and control package designed for C-series
and CVM1 PCs. It provides not only programming capabilities, but also
advanced debugging, monitoring, and program/data management. For further
information and actual operating procedures, please refer to the SYSMAC Sup-
port Software Operation Manuals: Basics and C Series .
Section
Cancel
Cancel
4-2