Omron CPM2C Operation Manual page 93

Error Log
PC Setup
4-1-3 Using the SYSMAC-CPT Support Software
Starting the Software
1, 2, 3...
The error log cannot be displayed. If data has been written to DM 6569 to
DM 6599, however, this data will be incorrectly displayed as the error log. Do not
use the information that is displayed.
Some of the CPM2C's PC Setup settings are different from those in the CQM1,
so not all settings can be made from the menus. These settings have to be made
by writing data directly to the word containing the setting.
This section shows how to perform basic SYSMAC-CPT Support Software op-
erations with the CPM2C PC. (The software is operating in a Windows 95 envi-
ronment in these examples.)
The SYSMAC-CPT Support Software is a Windows 3.1/Windows 98/Windows
NT (3.5/4.0) application. Refer to the SYSMAC-CPT Support Software User
Manual (W333) for details on computer requirements and the software installa-
tion procedure.
1. Select "Programs (P)" from the Start Menu, "SYSMAC-CPT," and then
"SYSMAC-CPT" to start the software.
2. Read the notes provided in the startup messages and click "OK."
3. The SYSMAC-CPT Support Software will start.
Note To exit from the SYSMAC-CPT Support Software, select "File (F)" from the menu
bar and "Exit (X)" from the File menu.
Section 4-1