Omron CPM2C Operation Manual page 39

4. Initial Settings
• Set the Communications Switches on the front of the CPU Unit, if neces-
sary. (The switches must be set when a device other than the Program-
ming Console is connected or the standard communications settings are
not used.)
• Connect the Programming Console, set the mode switch to PROGRAM
mode, and turn ON the PC.
• Check the CPU Unit's LED indicators and the Programming Console's dis-
play.
• Clear the PC's memory. (All Clear)
• Make PC Setup settings.
Refer to 3-3 Installing the CPM2C and 4-3-4 Preparation for Operation for
details.
5. Create Ladder Program
• Create a ladder program to control the system.
Refer to Section 4 Using Programming Devices and the Programming
Manual for details.
6. Write Ladder Program in PC
• Write the ladder program in the PC with the Programming Console or
transfer the program to the PC from the Support Software.
Refer to Section 4 Using Programming Devices, to the SYSMAC Support
Software Operation Manuals and to the CPT User Manual for details.
7. Test Run
• Check I/O wiring in PROGRAM mode.
• Check and debug program execution in MONITOR mode.
Refer to Section 5 Test Runs and Error Processing for details.
Section 1-6