Omron CPM2C Operation Manual page 128

4-4-26 Hex-ASCII Display Change
1, 2, 3...
4-4-27 Displaying the Cycle Time
1, 2, 3...
4-4-28 Reading and Setting the Clock
1, 2, 3...
3. Press the NOT Key to clear the force-set/reset status of bits in all data areas.
This operation is used to convert word data displays back and forth between
4-digit hexadecimal data and ASCII. It is possible in any mode.
RUN MONITOR
OK OK
1. Monitor the status of the desired word(s) according to the procedure
described in 4-4-12 Bit, Digit, Word Monitor .
(Multiple address monitor)
2. Press the TR Key to switch to ASCII display. The display will toggle between
hexadecimal and ASCII displays each time the TR Key is pressed.
This operation is used to display the current average cycle time (scan time).
It is possible only in RUN or MONITOR mode while the program is being
executed.
RUN MONITOR
OK OK
1. Press the CLR Key to bring up the initial display.
2. Press the MONTR Key to display the cycle time.
MONTR
There might be differences in displayed values when the MONTR Key is
pressed repeatedly. These differences are caused by changing execution
conditions.
This operation is used to read or set the CPU's clock in CPM2C CPU Units that
are equipped with an internal clock. The clock can be read in any mode, but can
be set in MONITOR or PROGRAM mode only.
Operation
Read clock OK
Set clock No
1. Press the CLR Key to bring up the initial display.
2. Press the FUN Key, SHIFT Key, and then the MONTR Key to display the
date and time.
FUN SHIFT MONTR
 
 
NOT
PROGRAM
OK
  
-- 
  
3 3 
TR
  
-- 
TR
PROGRAM
No
  
/
RUN MONITOR
OK
OK
  .., ,  
! -!   %&
Section 4-4
PROGRAM
OK
OK