Omron CPM2C Operation Manual page 95

Writing and Editing the
Ladder Program
Ladder-diagram format
Transferring the Program
The SYSMAC-CPT Support Software can display programs in ladder-diagram
format or mnemonic format. To switch the display/editing format, select
"View (V)" from the menu bar, "Program editor (P)," and then "Ladder (L)" or
"Mnemonic (M)."
Refer to 3-4-8 Programming Device Connections for details on connecting the
CPM2C to a personal computer.
Turn ON Communications Switch 2 before connecting the CPM2C to a personal
computer running the SYSMAC-CPT Support Software.
Note Do not turn ON Communications Switch 2 if the CPM2C is connected to a Pro-
gramming Console or other device such as a CPM1-CIF01/11 or
CQM1-CIF01/02. If the switch is turned ON, communications will be interrupted
and a communications error will occur. A Programming Console will become un-
responsive, key inputs won't be received, and the display will not change.
Operating Modes
The operating mode of the CPM2C when the power is turned ON depends upon
the PC Setup settings and the Programming Console's mode switch setting if a
Programming Console is connected. See 1-3-3 Operating Mode at Startup for
details.
The CMP2C has three operating modes: PROGRAM, MONITOR, and RUN.
When the CPT is offline, the CPM2C will operate in PROGRAM mode. When the
CPT is online, the CPM2C operating mode can be controlled from the CPT.
Mnemonic format
Communications Switch 2
(Turn ON when using SYSMAC-CPT
Support Software.)
Section 4-1