System Type; System Type Selection; Receiver Linking; Dual Receiver Function - FUTABA 32MZ Instruction Manual

System Type

System Type selection

The T32MZ is for 2.4GHz only. The system can be
changed from among 5 choices: FASSTest 18CH,
FASSTest 12CH, FASST MULTI, FASST 7CH,
S-FHSS, T-FHSS. Select the system matched to the
type of receiver you are using.u
*Even if it changes a system type, other model data is not
reset.e
*If a system type is changed in the case of a helicopter, It
can choose out of two channel orders.
[Yes] : Selection sets the channel order suitable for system
type. (We recommend here.)
[No] : The present channel order is maintained.
*All control surfaces should be checked for the correct
operating directions and operating smoothness before
lying the model.
*Analog servos cannot be used with the R7108SB in the
FASSTest 12CH mode.

Receiver linking

The receiver will only be controlled (without being
affected by other transmitters) by the transmitter it
is linked to. When using a receiver other than one
purchased as a set, linking is necessary.
Moreover, a re-link is required when a new model
is added by model selection, and the time of system
type change.
Dual receiver function (only FASSTest 18CH
mode)
Dual receivers can be linked with the T32MZ.
Two receivers are recognized individually by ID
numbers. For example, in R7108SB, CH output
setting function is used, by setting the irst as as
"1-8CH", and setting the second as "9-16CH",
two sets of receivers can be used as a set in the
● Touch the [System Type] button in the Linkage Menu
to call the setup screen shown below.
System mode setting, Receiver link
●Return to Linkage Menu
model, allowing you 16 channels. If a dual receiver
function is used, the following function can set up
individually.
・ Battery fail-safe voltage setup
A telemetry function cannot be used for the 2nd
receiver. The voltage and Ext voltage of a 2nd
receiver cannot be known with a transmitter.
Telemetry function (only FASSTest mode)
To use the telemetry function, set "Telemetry" to
"ON".
D/L Interval (only FASSTest mode)
When a telemetry function is enabled, the receiving
interval (down-link interval) of sensor data can be
changed.
If a D/L interval is increased, the response of
the sensor data display becomes slower, but stick
response will improve.
Battery fail-safe voltage setup (FASSTest/
T-FHSS mode)
The voltage which battery fail-safe activates, can
be set when you link. (3.5-8.4 V) The receiver
memorizes the setting as it was at link.
Suggested setting voltages are as follows.
• 4 cells NiCd or NiMH (Normal: 4.8 V) = 3.8 V
• 2 cells LiFe (Normal: 6.6 V) = 6.0 ~ 6.2 V
• 2 cells LiPo (Normal: 7.4 V) = 7.2 ~ 7.4 V
It is a rough reference value.
Since it changes with servos carried in the
condition and the model of a battery, please set to
your own model in a battery consumption current.
＜ Linkage Menu ＞
83