Table of Contents
Advertisement
Timer
Timer setting and lap time display. (and Sub-display)
The Timer function may be set for any desired time,
i.e. engine run time, specified times for competitions,
etc. Two independent timers are provided for your use.
The timers are stored independently with each model,
meaning that when you switch between model setups,
the timer associated with the new model is brought up
automatically.
The timers may be set to start and stop from the motion
of any switch or stick. You may set the ON and OFF
directions freely. Each timer has a capacity of up to 59
minutes 59 seconds.
● Touch the [Timer] button in the Linkage Menu to
call the setup screen shown below.
●Return to Linkage Menu
● Memory is turned ON, the
power OFF and a model
change will not be reset
timer, either.
Up timer/Down timer/Hour selection
1. Touch the mode button and select the type of
timer.
2. Timer time setting.
Touch the Mode minutes or seconds button.
Adjustment buttons appear on the screen.
Use these buttons to set the timer time.
Start/SW switch setting
1. Touch the Start/Stop SW "NULL" button to call the
<Switch> screen, and then select the switch and its
ON direction.
(For a detailed description of the selection
method, see [Switch Setting Method] at the
back of this manual. The timer switches can
be set for each condition.)
Lap time switch selection
1. Touch the Lap SW "NULL" button to call the Prog.
Mix screen, and then select the switch and its ON
direction.
(For a detailed description of the switch
setting method, see [Switch Setting Method]
at the back of this manual. The timer switches
can be set for each condition.)
Each timer may be set for count-down or count up
operation with your choice of a target time. Also split
time may be set up and counted.
If a target time is set and the timer reaches this point, a
buzzer will sound for each count generated.
Countdown timers sound one short beep during the last
twenty seconds and two short beeps during the last ten
seconds before reaching the target, then a long tone at
the target time, and continue counting with displaying a
minus (-) sign. Count-up timers also beep the last twenty
and ten seconds, beep the target time, and keep counting
upwards until shut down.
● [↑]An alarm sounds every minute
of the elapsed time from timer
start. (Conventional mode)
[↓]An alarm sounds every minute
of the remaining time up to the
alarm time.
<Lap time list>
Timer operation
● Timer 1 and Timer 2 are started and stopped by
your choice of switch.
● To count the lap time, select the lap time switch.
Each time this switch is operated, the lap time
is stored. To display the lap time, touch the
respective [List] button.
● To reset a timer, touch the respective [Reset]
button. To exit the setting, touch the [Timer] button.
Hour mode
An HOUR mode which counts up to 99 hours 50
minutes has been added to the timer modes.
● This mode is convenient when used at engine
m a i n t e n a n c e p e r i o d a n d o t h e r l o n g - t e r m
measurements.
● When the HOUR mode is set, "xx (hour) : xx (minute)"
is displayed on the count time display. Seconds
are not displayed.
● When the HOUR mode is set, ":" blinks each second
during timer operation.
● When the HOUR mode is set, the alarm function/lap
time measurement function are inhibited.
In case of helicopter type
ON: The timer 2 is displayed on
the home screen.
OFF (default): Timer 2 is not
d i s p l a y e d o n t h e h o m e
screen. Display of 1 timer and
THR Stick Pos and Pitch.
●Return to Timer
screen
＜ Linkage Menu ＞
97
Advertisement
Table of Contents
