S.bus2 System - FUTABA 32MZ Instruction Manual

S.BUS2 System

When using the S.BUS2 port, an impressive array of telemetry sensors may be utilized.
S.BUS Servo
Receiver port
S.BUS Gyro
S.BUS
S.BUS2
（※）Don't connect S.BUS Servo, S.BUS Gyro
to S.BUS2 connector.
S.BUS servos and gyros and S.BUS2
servos and gyros must be used in the
correct receiver ports. Please refer
to the instruction manual to make
sure you connect to the correct one.
Mixed connection
of S.BUS and S.BUS2
34
＜ Before Use ＞
S.BUS2 TABLE
S.BUS2
S.BUS2
○ ○
× （※） ○
Hub
S.BUS Servo
S.BUS2 servo
Connection is possible
S.BUS2 gyro
is possible.
Connection is possible
Telemetry sensor
Connection is impossible
Servo Telemetry
Gyro sensor
×
○
CH Mode is set
to ModeB [D].
Hub
S.BUS2 Servo
S.BUS servo
Connection is impossible
S.BUS
Port
(8/SB)
S.BUS2
Port
Hub
Hub
Telemetry
Sensors
S.BUS2
GYRO
＋
Servo