H/W Setting - FUTABA 32MZ Instruction Manual

H/W Setting

This function is for adjusting the sticks, switches, and
trim characteristics. It is not unless necessary.
H/W Reverse
This function reverses the operation signal of the sticks,
switches, trimmer levers, and knobs.
Note: This setting reverses the actual operation signal,
but does not change the display of the indicators
on the display. Use the Normal mode as long
as there is no special reason to use the Reverse
mode.
● Touch the [H/W Setting] button at the System Menu to
call the setup screen shown below.
● Touch the [H/W Reverse] button at the H/W Setting
Menu to call the setup screen shown below.
Operation direction reversal method
1. Touch the setting button corresponding to the H/W
(Hardware) you want to reverse.
2. Reverse the H/W by touching [Yes]. (When you
want to stop operation, touch [No].)
[Normal]: Normal operation direction
[Reverse]: Reverses the operation direction.
Stick, switch, trim lever, and knob operation direction
reversal (Hardware reverse)/Stick response and
hysteresis adjustment (Stick Setting)/Calibration
●Return to System Menu
●Return to H/W Setting Menu
Stick Setting
This function sets the servo response and hysteresis for
stick operation for each condition. The control feeling of
the stick can be adjusted to match the aerobatics.
Calibration
Usually, this calibration is unnecessary.
Please perform this calibration, only if a change at the
center of a stick should arise after prolonged use.
＜ System Menu ＞
65