Model Type - FUTABA 32MZ Instruction Manual

Model Type

Seven types of main wings and three types of tail
wings are available for airplanes. Eight swash types are
available for helicopters. Seven types of main wings
and three types of tail wings are available for gliders.
Functions and mixing necessary for each model type are
set in advance at the factory.
● Touch the [Model Type] button in the Linkage Menu to call the setup
screen shown below.
(The display screen is an example. The screen depends on the model type.)
Model type selection
1. Set the Model type, Wing type, Tail type, or Swash
type by using the appropriate button.
2. Set the type you choose by touching [Yes] at the
confirmation screen. (When you want to cancel
model type selection, touch [No].)
78
＜ Linkage Menu ＞
This function allows you to select the model type
from among airplane, helicopter, and glider.
●Return to Linkage Menu
●When a data change will occur, the conirmation screen of
data initialization menu will be displayed.
A push on [yes] will initialize data and allow changes.
A push on [no] will stop data changes.
Note: The Model Type function automatically selects
the optimal output channels, control functions, and
mixing functions for the chosen model type. When
the Model Type Selection is accessed, all of settings
in the active model are cleared. Be sure that you
don't mind losing this data, or back it up to memory
using the copying functions.
Date changes after a swash type change
Data that has been set may change if the swash
type of your helicopter is changed.
(Refer to the following table) When data is changed
the [swash setting] screen is initialized.
Before After
H-1, H-2, HE3, H-1, H-2, HE3,
HR3, HN3, H-3 HR3, HN3, H-3
H-4, H-4X H-4, H-4X
H-1, H-2, HE3,
H-4, H-4X
HR3, HN3, H-3
H-1, H-2, HE3,
H-4, H-4X
HR3, HN3, H-3
Data taking over
OK
OK
NG
NG