Dial Monitor - FUTABA 32MZ Instruction Manual

Dial Monitor

Digital trim position display (T1-T6)
The Dial Monitor displays the current position and step
amount of each digital trim. The trim step can be set
directly on the dial monitor.
VR and slide lever position display (LST, LS, LD,
RD, RS, RST)
Displays the current position (black ) and last operating
position (green ) of the VRs and slider levers.
● Touch the [Dial Monitor] button in the Linkage Menu to call
the setup screen shown below.
●Return to Linkage Menu
Knob and Lever Position display
(LST, LS, LD, RD, RS, RST)
The Dial Monitor displays the current position and last
operating position of each knob and lever. Although
neither knob nor lever can hold the last operation position
as they are "analog" type, the position data during the
last operation is memorized in the model memory. By
moving the knob and lever to the position displayed on
the monitor, the last operation position is recalled.
Displays the position of the dials, slider levers,
and digital trim.
● Trim changes from the step to % display.
Digital trim step amount (T1-T6)
The trim step of the T1-T6 can be set directly on the dial
monitor menu.
●Digital trim step amount
Recalling Dial Position
(LST, LS, LD, RD, RS, RST)
The dial position data at the last operation is displayed
for each knob and lever in this monitor. (Green arrow)
1. Move the black arrow (current position) to the
green arrow position by operating the desired
knob or lever to recall the last operating position.
＜ Linkage Menu ＞
99