4. System Maintenance
4.
When the position adjustment screen with 25 points is displayed, touch with the pen in the
order that X on the screen is highlighted in yellow.
5.
Turn the main part OFF/ON after finishing the above check procedure.
Finger drawing mode
This product usually receives the written signal of the pen when the infrared signal of the electronic pen is
ON. When the electronic pen or the location sensor has a defect, by using the "Finger drawing mode"
which ignores the infrared light of the pen, the problem can be isolated.
1.
Open Finger writing mode from the service mode.
2.
Touch [Finger].
3.
Start up the whiteboard with the finger mode setting, and check that a line can be written.
4.
The problem is isolated by the check result.
When a line can be written: Position sensor is operating normally.
When a line cannot be written: Position sensor is not operating normally.
5.
Turn the main part OFF/ON after finishing the above check.
102