Change Electronic Pen Id - Ricoh IWB-D1 Field Service Manual

• In the Finger drawing mode, since the drawing signals are always ON, a line can be written only
like writing with one stroke. Always turn the power OFF/ON after the above procedure in order to
return to the usual pen mode.

Change Electronic Pen ID

1. Remove the battery of the electronic pen.
2. When installing the battery, push the side button and the end of the pen, then the LED will
blink.
• Push the side button of the pen with a tip of a clip, etc. because the diameter of the hole is very
small.
3. The ID number of a pen is 1 with the default setting and changes to 2-7 in order by the
number of times the above procedure is done. After 7, it returns to 1.
Initial value: ID number 1
1st change: ID number 2
2nd change: ID number 3
3rd change: ID number 4
4th change: ID number 5
5th change: ID number 6
6th change: ID number 7
Service mode
103