Table of Contents
Advertisement
Figure 20
1. Positive (+) cable on discharged battery
2. Positive (+) cable on booster battery
3. Negative (–) cable on the booster battery
4. Negative (–) cable on the engine block
5. Booster battery
6. Discharged battery
7. Engine block
4.
Connect the other end of the positive cable to
the positive terminal of the booster battery.
5.
Connect the black negative (–) cable to the other
terminal (negative) of the booster battery.
6.
Make the final connection on the engine block
of the stalled vehicle (no to the negative post)
away from the battery. Stand back.
7.
Start the vehicle and remove the cables in the
reverse order of connection (the engine block
(black) connection is the first to disconnect).
Drive System
Maintenance
Checking the Tire
Pressures
Service Interval: Every 50 hours
1.
Park the machine on a level surface, disengage
g012785
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Check the tire pressure in drive tires.
4.
Inflate the drive tires to 83 to 97 kPa (12 to 14
psi).
5.
Semi-pneumatic caster tires do not need to be
inflated.
Wheel Hub Nut Torque
Specification
Service Interval: After the first 100 hours
Every 500 hours thereafter
Check and torque the nut on the wheel motor tapered
shaft to 156 to 183 N∙m (115 to 135 ft-lb).
Note:
Do not use anti-seize compound on the wheel
hub.
31
Advertisement
Table of Contents
