User Interface Events That Will Terminate A Remote Session - Fluke OptiView III Series Getting Started Manual

OptiView TM Series III
Getting Started Guide

User Interface Events that will Terminate a Remote Session

The active TCP/IP session between the user interface software and the analyzer
can be severed under the following conditions:
•
•
•
•
•
•
•
•
•
•
In the previous conditions, the popup message There are <n> user interfaces that
may lose connection to the remote OptiView Analyzer, proceed anyway? With
both the Yes and No buttons displayed.
36
Figure 20. OptiView Personal Web Server Home Page
If IP parameters are manually changed on the analyzer and Apply is selected in
the Setup | TCP/IP screen
If Auto Reconfigure on Network Change is checked in the TCP/IP setup screen
and the analyzer patch cable is disconnected and reconnected to another jack
If the Ethernet link goes down due to temporary network outage
If Rerun Auto Config is selected in the TCP/IP setup screen
If the encryption is changed in the Setup | Remote screen
If Find Unused IP and Apply is selected in the TCP/IP setup screen
If Rerun Cable Test is selected
If the Analyzer MAC address is changed in the Setup | Ethernet screen
If Receive only, do not transmit frames is selected in the Setup | Ethernet
screen
Changing the User Account
aww46s.bmp