User Interface Events That Will Terminate A Remote Session; Setting Up The Analyzer Security - Fluke OptiView II Series Getting Started Manual

OptiView TM Series II
Getting Started Guide

User Interface Events that will Terminate a Remote Session

The active TCP/IP session between the user interface software and the analyzer
can be severed under the following conditions:
•
•
•
•
•
•
•
•
•
In the previous conditions, the popup message There are <n> user interfaces that
may lose connection to the remote OptiView Analyzer, proceed anyway? With
both the Yes and No buttons displayed.

Setting Up the Analyzer Security

The Setup | Security screen provides analyzer security settings for packet capture,
remote access, and SNMP configuration.
The Setup | Ethernet screen allows you to select Receive only, do
not transmit frames, which turns off the analyzer transmit capability,
thus putting it on the network in silent mode. Turning off the analyzer
transmit capability disables the device query for name resolving and
other active tests such as Ping.
The analyzer's MAC address can also be changed in the Setup |
Ethernet screen for testing switch forwarding tables or ARP caches.
36
If IP parameters are manually changed on the analyzer and Apply is selected in
the Setup | TCP/IP screen
If Auto Reconfigure on Network Change is checked in the TCP/IP setup
screen and the analyzer patch cable is disconnected and reconnected to
another jack
If the Ethernet link goes down due to temporary network outage
If Rerun Auto Config is selected in the TCP/IP setup screen
If the encryption is changed in the Setup | Security screen
If Find Unused IP and Apply is selected in the TCP/IP setup screen
If Rerun Cable Test is selected
If the Analyzer MAC address is changed in the Setup | Ethernet screen
If Receive only, do not transmit frames is selected in the Setup | Ethernet
screen
Note