Supported Network Standards; Cable Types; Cable Length; Fault Tolerance - Fluke OptiView III Series Getting Started Manual

OptiView TM Series III
Getting Started Guide

Supported Network Standards

IEEE 10BASE-TX,
IEEE 100BASE-TX,
IEEE 1000BASE-TX,
IEEE 1000BASE-X

Cable Types

Unshielded Twisted Pair LAN cables (100 and 120 Ohm UTP category 3, 4, 5, 5E,
and 6 ISO/IEC Class C and D)
Foil-screened Twisted Pair cables (100 and 120 Ohm ScTP category 3, 4, 5, and 6
ISO/IEC Class C and D)

Cable Length

Measurable cable lengths are from 3 feet (.9 meter) to 500 feet (152 meters).
Within this cable length, the accuracy is +-6 feet (+-2 meters).
Length accuracy is dependent upon the cable type selected in the
Cable Test screen with its ideal NVP (nominal velocity of
propagation) matching the NVP of the cable under test.

Fault Tolerance

The RJ-45 10/100/1000BASE-T Ethernet connection on the analyzer is designed
to withstand a maximum of 100 volts.

Environmental Requirements

Operating Temperature
Note: Battery will not charge below 12°C (53.6°F)
Non-Operating Temperature
Altitude
56
Table 6. Supported Network Standards
LAN Interfaces
RFCs: 1213, 1231, 1239, 1285, 1315,
1493, 1512, 1513, 1643, 1757, 2021,
2108, 2115, 2127, 2495, 2496, 2515,
2558
Standard SNMP MIBs Used
Note
10°C to 30°C (50°F to 86°F) with up to 95%
Relative Humidity
10°C to 40°C (50°F to 104°F) with up to 75%
Relative Humidity
-40°C to +71°C (-40°F to +159.8°F)
Operates up to 4600 meters (15091 feet)